Option to install new heating and cooling system at rental property.
- Removal of existing heating and cooling system. Haul away all old equipment and trash.
- Seal existing platform and clean out return cavity.
- Install Carrier 4 ton 70k BTU comfort series up flow furnace.
- Install Carrier 4 ton 14 SEER R410A comfort condenser.
- Install Carrier 4 ton high efficiency evaporator coil.
- Estimated energy savings around 30-40%.
- Flush refrigerant lines.
- Install new filter base to bottom of furnace, and provide disposable filter.
- Install new gas valve, flex, and sediment trap per code.
- Hook up new 120v electrical pigtail.
- Hook up all low voltage wire.
- Hook up flu pipe to existing double wall venting that is present.
- Seal evaporator coil and plenium box to reduce any air loss.
- Flush out condensation line and hook up new coil to existing primary line.
- Install safety float switch on secondary line at the coil.
- Install condenser on a new matching 4 ton pad.
- Install 60 amp electrical disconnect box with matching fuses.
- Install ¾ in electrical whip.
- Install programmable thermostat.
- Seal all duct joints to prevent air loss and improve comfort as well as efficiency.
- Test heating and cooling system to ensure proper operation.
- Balance airflow throughout home for increased comfort.
Total investment cost …….……………………………………………………….………………. $7,000.00