Honda Accord Distributor O Ring Replacement

来源: zwang1822 于 2012-03-07 07:57:55 [] [博客] [旧帖] [给我悄悄话] 阅读数 : (6004 bytes)
本帖于 2012-03-07 08:31:28 时间, 由版主 biglow 编辑

1. Disconnect the negative cable from the battery;
2. Mark the location of each wire, then take ignition wires off the distributor cap.


3. Rotate engine from this hole by using 19mm socket.



4. Get the piston in the No. 1 cylinder to the Top Dead Center (TDC) spot. 



5. Make sure rotor is pointing to No. 1 cylinder cable position.



6. Make the marks between distributor housing and engine block.





7. Carefully take distributor out from the engine.





10. Clean the parts and install the new o ring to the distributor and the install the distributor to the engine.

11. Connect all wire and cables and you are done !



请阅读更多我的博客文章>>>

  • 我家的大柳树
  • 茉莉花开
  • 2000 Honda Accord Timing Belt and Water Pump Change
  • 看我修冰箱
  • Cylinder Wheel Boot and Brake Shoe

    • 所有跟帖： 

    • 酷.看不懂.不过见到拆东西的俺就觉得酷 -满地找牙- ♂ 给 满地找牙 发送悄悄话 满地找牙 的博客首页 (40 bytes) () 03/07/2012 postreply 08:07:21

    • 分电器密封圈老化后会漏机油，可能影响其正常工作，更不美观，所以换之 -色大胆小- ♂ 给 色大胆小 发送悄悄话 色大胆小 的博客首页 (0 bytes) () 03/07/2012 postreply 08:26:20

    • 谢 -满地找牙- ♂ 给 满地找牙 发送悄悄话 满地找牙 的博客首页 (0 bytes) () 03/07/2012 postreply 08:52:32

    请您先登陆，再发跟帖！