Honda Accord Distributor O Ring Replacement

1. Disconnect the negative cable from the battery;
2. Mark the location of each wire, then take ignition wires off the distributor cap.


3. Rotate engine from this hole by using 19mm socket.



4. Get the piston in the No. 1 cylinder to the Top Dead Center (TDC) spot. 



5. Make sure rotor is pointing to No. 1 cylinder cable position.



6. Make the marks between distributor housing and engine block.





7. Carefully take distributor out from the engine.





10. Clean the parts and install the new o ring to the distributor and the install the distributor to the engine.

11. Connect all wire and cables and you are done !



请阅读更多我的博客文章>>>