after disconnect the hard drive

I put a new hard drive in without change the jumper to "slave", but when I disconnect it from the computer, just left the old HD, the computer can't boot to window.

When I went in the bois, it show" primary IDE master and slave not detected".

when i ture on the computer, after the logo, it come out a message:

"reboot and select proper boot device or insert boot media in selected boot device and press a key".

What can I do for this? Thanks!

所有跟帖： 

• It is so difficult to understand!! I can not help you without ch -69202- ♀ (87 bytes) () 01/02/2006 postreply 17:34:19

• 我把前几天装的新硬盘裁下来后 -6890- ♀ (225 bytes) () 01/02/2006 postreply 18:27:06

• Try This -westmont- ♂ (155 bytes) () 01/02/2006 postreply 18:17:08

• the old hard drive's jumper is set to master -6890- ♀ (44 bytes) () 01/02/2006 postreply 18:31:06

• 是不是所有的MASTER HD 都应接在 -6890- ♀ (43 bytes) () 01/02/2006 postreply 19:15:44

• 改下 boot sequence -小鸡- ♂ (0 bytes) () 01/03/2006 postreply 06:04:44

• try that, but not working -6890- ♀ (0 bytes) () 01/04/2006 postreply 06:30:21

• Could be just loose connections to the old drive -redman- ♂ (40 bytes) () 01/05/2006 postreply 19:15:30