Busy Signal in the first incoming (Cisco 7940)

Hi,

I set up a home voip phone system. I use ipkall and forward to voipdiscount and ring my cisco 7940. The problem is that the first incoming call will get busy signal. If the following incoming call is place within short of time, then the incoming call can ring the cisco 7940 phone. If there is no incoming call for a long time ( a few minutes), then the first incoming call will get busy signal again. Here is the link that I followed to setup my system.

http://afxa9.comxa.com/

Thanks!

所有跟帖： 

• 回复：Busy Signal in the first incoming (Cisco 7940) -chat092- ♂ (109 bytes) () 06/07/2010 postreply 02:24:23

• 设置 timer_register_expires -afxa9- ♂ (355 bytes) () 06/07/2010 postreply 11:55:16

• 回复：设置 timer_register_expires -xialele- ♀ (589 bytes) () 06/07/2010 postreply 18:43:24

• 回复：回复：设置 timer_register_expires -afxa9- ♂ (362 bytes) () 06/07/2010 postreply 19:05:22

• 回复：回复：回复：设置 timer_register_expires -xialele- ♀ (277 bytes) () 06/08/2010 postreply 19:35:59

• yes, it's for ip phone. After save the setup, no reset needed -afxa9- ♂ (0 bytes) () 06/09/2010 postreply 23:47:01