Report to DDY and other Gurus: Deploy failed

I followed the instruction from DDY:
在电脑A上资源管理器device management的“IDE ATA/ATAPI控制器”中找到当前正在使用的IDE控制器，右击鼠标之后从弹出菜单中选择“更改驱动程序”命令，接着在出现的驱动程序更新向导中依次选择“从列表或指定位置安装→不要搜索，我要自己选择要安装的程序”，最后从窗口中选取“标准双通道PCI IDE控制器”一项即可。

在WindowsXP光盘中，找到supporttools下一个名为deploy.cab的压缩包，把它解压缩，运行其中的sysprep.exe文件，然后什么都可不设置，直接确定即可，于是计算机会自动关闭。

将硬盘放到电脑B上，开机，按提示一步一步做许了，就象对一个新电脑的首次开机一模一样。我做过好多回，没问题。但如果电脑A上有多个硬盘，一定要将其它硬盘卸掉（拔线就行）
When attempting to run sysprep.exe, I was asked to run setupCl too. I did and then I had two choices: Reseal and Factory. I chose reseal since it is the default choice.
Then the sysprep ran and the computer shut off itself.
After moving that hard drive to Computer B, it could not boot up to windows. The choices were: safe mode, safe mode with networking, and normal. I tried them one by one but all failed.
Maybe I should choose Factory? Please help.

所有跟帖： 

• 回复：Report to DDY and other Gurus: Deploy failed -ddy- ♂ (2317 bytes) () 02/08/2008 postreply 18:43:30

• 回复：Report to DDY and other Gurus: Deploy failed -ddy- ♂ (324 bytes) () 02/08/2008 postreply 20:47:09

• 太谢谢了，已收藏 -保罗X世- ♂ (0 bytes) () 02/09/2008 postreply 19:15:17