Don't use open end fixed wrenches.

来源: jassco 于 2023-08-03 17:48:38 [] [旧帖] [给我悄悄话] 阅读数 : (229 bytes)
回答: 螺丝太紧有点滑丝了，怎么补救 由 DC_Jeeper 于 2023-08-03 16:33:28

Use an adjustable crescent wrench. File surfaces to make them flat. Use a hammer to hit the crescent wrench to create an impact. Spray some BP blaster penetrating oil if you have.

Good luck!

Alex

所有跟帖： 

• 谢谢，锉刀先锉平似乎有道理 -DC_Jeeper- ♂ 给 DC_Jeeper 发送悄悄话 (69 bytes) () 08/03/2023 postreply 18:12:13

• It is caused by -jassco- ♂ 给 jassco 发送悄悄话 (215 bytes) () 08/03/2023 postreply 20:08:37

请您先登陆，再发跟帖！