换完减震器要不要做Alignment.
下面是我刚搜的。减震器拆了又装，我也没看见在哪做camber,caster。我知道toe是调方向杆。
原来就根本没地方调，唯一能做的就是松了上面的四个螺丝转转。
Usually Camber and Caster can only be minimally adjusted on FWD. The only way you could do it is removing the outer 4 strut mount bolts, jack the control arms up and rotate the strut 90 degrees of a turn at a time and watch the monitor if it gets any closer to the right spec. I think you could only turn it 4 times until it goes back to where it was before alignment, not much of a difference. If there is excessive angle out of alignment, then something must been bent or somebody moved the cradle of the engine bay when they worked on it.
