google来的,自己掂量吧

来源: 满地找牙 2012-04-30 10:59:55 [] [博客] [旧帖] [给我悄悄话] 本文已被阅读: 次 (5883 bytes)
回答: 请问99年的Caravanhusky2012-04-30 10:30:24

http://www.obd-codes.com/p0201

 

P0201 - Cylinder 1 Injector Circuit Malfunction

Article by

Dale Toalston
ASE Certified Technician

OBD-II Trouble Code Technical Description

Cylinder 1 Injector Circuit Malfunction

What does that mean?

P0201 means that the PCM detected a fault in the injector or the wiring to the injector. It monitors the injector and when the injector is activated, the PCM expects to see the voltage pulled "low" or close to zero. When the injector is switched off, the PCM expects to see a voltage that is close to battery voltage or "high". If it doesn't see the expected voltage the PCM will set this code. The PCM also monitors resitance in the circuit. If the resistance is excessively low or high it will set this code.

Potential Symptoms

The symptoms for this code will likely be a misfire and a rough running engine. Poor acceleration. The MIL will also be illuminated.

Causes

The causes could be any of the following:

  • Bad injector. This is usually the cause of this code but doesn't rule out the possibility of one of the other causes
  • Open in the wiring to the injector
  • Short in the wiring to the injector
  • Bad PCM

Possible Solutions

  1. First, using a DVOM check the resistance of the injector. If it isn't within specs, then replace the injector.
  2. Check for voltage at the fuel injector connector. It should have 10 volts or more.
  3. Visually check the connector for damage or broken wires.
  4. Visually check the injector for damage.
  5. If you have access to an injector tester, activate the injector and see if it operates. If the injector operates, then you likely have either an open in the wiring, or a blocked injector. If you do not have access to a tester, swap the injector with another one and see if the code changes. If the code changes, then change the injector.
  6. At the PCM, remove the driver wire from the PCM connector and Ground the wire. (Make sure you have the correct wire. If you're not sure, do not attempt) The injector should activate
  7. Replace the injector
请您先登陆,再发跟帖!

发现Adblock插件

如要继续浏览
请支持本站 请务必在本站关闭/移除任何Adblock

关闭Adblock后 请点击

请参考如何关闭Adblock/Adblock plus

安装Adblock plus用户请点击浏览器图标
选择“Disable on www.wenxuecity.com”

安装Adblock用户请点击图标
选择“don't run on pages on this domain”