试一下土办法,很多年前的技巧,记得也许不准

1, identify the start relay at power center, remove it and ignition key on, the connect female pin #30 and # 87 with a cross wire, car will crank, take it off until engine start, put the relay back on the socket, drive for 5 minute, shut off engine. try to start later.
2, locate ecm, it is normally located on the front of firewall, pass. side, behind shock tower. there are 3 or 4 boxes, don't confuse, you need find engine control module. check pin #66 green wire that is for start control, cut the wire after ignition key off and battery negative cable removed. put negative cable back and try to start engine. this will disable the anti-theft system.
3, make sure battery fully charged, clear security system code with a scanner, GT1, or MT2500 with euro software, Vedis, or Solus pro, etc. try to start engine.

所有跟帖： 

• 防盗系统锁了,乱拔保险丝惹的祸. -fixanycars- ♀ (0 bytes) () 01/18/2010 postreply 19:11:11

• 刚想起,方法2时, 连接BATTERY负级线前应IGNITION KEY ON -fixanycars- ♀ (0 bytes) () 01/18/2010 postreply 19:22:30

• 需要解释一下， -曲线救国- ♂ (204 bytes) () 01/18/2010 postreply 20:19:01

• 先试这招,简单 -fixanycars- ♀ (406 bytes) () 01/18/2010 postreply 20:39:09

• 3, 启动挡松手后的挡位既是"on"档. -fixanycars- ♀ (0 bytes) () 01/18/2010 postreply 20:45:44

• 好。明天试试，回头再汇报。多谢，，， -曲线救国- ♂ (0 bytes) () 01/18/2010 postreply 21:03:01

• 中午试了一下，还不行 -曲线救国- ♂ (20 bytes) () 01/19/2010 postreply 13:35:35

• 3把钥匙应该每把都试,如果全不能识别, 建议用GT1或SSS CODING/PROGRM -fixanycars- ♀ (120 bytes) () 01/19/2010 postreply 15:29:17

• 试时要把车门关好,HOOD 关好,如电平在TRUNK里. -fixanycars- ♀ (0 bytes) () 01/19/2010 postreply 15:31:24

• 现在只有一把钥匙。 -曲线救国- ♂ (201 bytes) () 01/19/2010 postreply 15:47:37