If brake light is on, you may need brake fluid.

来源: BigV8 于 2010-09-17 12:20:24 [] [旧帖] [给我悄悄话] 阅读数 : 0 (567 bytes)
回答: thank you very much. Excellent advice. 由 verilog 于 2010-09-17 11:59:32

What is the problem? Worn out brake pads or brake fluid leaking?
What is dealer's advise? You may want to look into their advise and analyze it. So you can figure out what need to be done correctly.
To change rotor and pads, you need to have:
2 floor stands
Jack
Some wranches or sockets. I think they are between 10-18.(I do not think you need to remove big center axle nut to change rotor on Toyotas.)
A spray can of brake cleaner to take off any grease on rotor surface.
A hammer will be handy to loose tight bolt or take off sized rotor.

所有跟帖： 

• brake fluid is fine. break light is on and off! -verilog- ♂ 给 verilog 发送悄悄话 verilog 的博客首页 (283 bytes) () 09/17/2010 postreply 12:56:42

• Does the car has pad sensors? If not, -BigV8- ♂ 给 BigV8 发送悄悄话 (168 bytes) () 09/17/2010 postreply 13:46:53

• good question! -verilog- ♂ 给 verilog 发送悄悄话 verilog 的博客首页 (231 bytes) () 09/17/2010 postreply 13:55:20

• Dealer mechanic knows everything. What they recommend is -BigV8- ♂ 给 BigV8 发送悄悄话 (149 bytes) () 09/17/2010 postreply 14:03:17

• I see, thank you. Will check it this weekend! -verilog- ♂ 给 verilog 发送悄悄话 verilog 的博客首页 (0 bytes) () 09/17/2010 postreply 14:21:00

请您先登陆，再发跟帖！