Check power steering pump...

来源: internuts 于 2008-08-11 16:46:20 [] [博客] [旧帖] [给我悄悄话] 本文已被阅读： 0 次 (255 bytes)
回答: Check fluid level in power steering pump. 由 色大胆小 于 2008-08-11 14:34:45
Check the PS belt - the pump bearing could be stuck so the belt couldn't move, hence the belt was burned. If that is the case, you can buy a used PS pump from junk yard and put it on (it's an easy DIY).

Also check PS fluid leaking... Good luck!

所有跟帖： 

• 对把发动机开了，看看，ps一般位置都挺显眼的 -sheandI- ♂ 给 sheandI 发送悄悄话 sheandI 的博客首页 (0 bytes) () 08/11/2008 postreply 17:15:37

• 是turn on，不是拆开。。。呵呵 -sheandI- ♂ 给 sheandI 发送悄悄话 sheandI 的博客首页 (0 bytes) () 08/11/2008 postreply 17:22:40

• 再请问一下,我看了些PUMP,都不带BELT的,我是不是还要买 -SunOfBeach- ♂ 给 SunOfBeach 发送悄悄话 SunOfBeach 的博客首页 (9 bytes) () 08/12/2008 postreply 08:13:26

• Not quite sure with Mazda... -internuts- ♂ 给 internuts 发送悄悄话 internuts 的博客首页 (184 bytes) () 08/12/2008 postreply 17:41:04

• thanks a lot. I will do that -SunOfBeach- ♂ 给 SunOfBeach 发送悄悄话 SunOfBeach 的博客首页 (0 bytes) () 08/13/2008 postreply 12:10:02

请您先登陆，再发跟帖！

发现Adblock插件

如要继续浏览
请支持本站 请务必在本站关闭/移除任何Adblock

关闭Adblock后 请点击

请参考如何关闭Adblock/Adblock plus

安装Adblock plus用户请点击浏览器图标
选择“Disable on www.wenxuecity.com”

安装Adblock用户请点击图标
选择“don't run on pages on this domain”