为什么还没有Ready涅，肿么才能Ready涅，针对Toyota的最后一招！:-)

要做就严格按照以下要求做，要不就不做，希望能解决你的Not Ready顽疾

Fuel tank at 1/2

Engine cold start idle for 10 minutes.

Drive highways speed 55-60 mph with steady throttle for 16 minutes.

Return to idle for 3 Minutes.

Drive at medium speed 40 mph for 8 minutes.

Return to idle for 3 minutes.

Repeat next day.

 

One monitor requires a minimum temperature of 40 deg. F

If your climate is below this temperature at night the evap monitor will not complete. You must park the vehicle in a heated garage above 40 deg. F for 12 hours with the key off and fuel tank at 1/2 to run the evap monitor.

 

If there are pending malfunctions that have not yet turned on the malfunction light, the monitors will not become ready. In this case you must continue the drive cycles until the malfunction shows up.

 

Its helpful to have your own scan tool to know the status of the readiness monitors. If you don't have one and don't want to buy one, some auto parts stores will rent them.

 

Some auto parts stores like AutoZone will scan the codes and check your monitors free of charge.

Source 出处: 为什么没有Ready涅，肿么才能Ready涅？