Put the key in the ignition, and turn forward all the way just before cranking. Then within 5 seconds, locate, press and hold in the valet/overide button, found under the dash area, (push button, spring loaded) until the installed LED (the blinking light) in your dash area goes on solid, and the siren chirps once. (Your valet switch might be the toggle (on/off) type. in this case, key on, flip switch in opposite direction, then turn the key off.) This should reset the alarm, and reset the grounded relay on the starter wire, allowing you to start the engine. At this point, the only thing working would be the keyless entry from the alarm, if it came equipped that way. Just Repeat these steps to place it back to usable armed mode. You may get 2 chirps, confirming it, and the lights may flash twice as well. That should do it.
试一试
所有跟帖:
• 好像没有那个 valet/overide 按钮。 -hua126- ♂ (276 bytes) () 04/17/2015 postreply 13:33:23
• 建议打电话到Ford Dealer问一问 -soccer88- ♂ (0 bytes) () 04/17/2015 postreply 13:45:42
• 打了,说是电池没电了,要 jump start。 -hua126- ♂ (0 bytes) () 04/17/2015 postreply 14:03:09
• 是电池没电了。换了个电池,谢谢 soccer88 ! -hua126- ♂ (0 bytes) () 04/17/2015 postreply 16:29:10
• 好啊,问题不大,嘿嘿 -soccer88- ♂ (0 bytes) () 04/17/2015 postreply 16:33:42